+-
« previous next »
Pages: [1]   Go Down

Author Topic: wiseco piston to cyl clearance?  (Read 389 times)

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 34
  • Gender: Male
  • Location: California
wiseco piston to cyl clearance?
« on: February 12, 2013, 11:14:18 am »
I have 89.00mm piston. Wiseco recommends .0034. I think I remember Q recommends a min. of .0055 if U ride hard in the dunes. Anyone else care to share what clearance they run? 
Logged

Share on Bluesky Share on Facebook

Offline

  • CEO BRP
  • Trade Count: (0)
  • Trail Blazer
  • ******
  • Posts: 772
  • BRaP Small block 302, Released and Running
Re: wiseco piston to cyl clearance?
« Reply #1 on: February 12, 2013, 12:11:25 pm »
If you are meticulous about breakin and jet it correctly. .004. just be sure it dosent run lean and the shop that bores it gets it round and straight. .045 if your nervous. Remember at .008 its gonna rattle. when you start it.

Two years ago, I put a brand new engine on the Ice with .038" clearance It had been through a dozen heat cycles and its first ride was in practice. Its all about break in/warm up and proper tuning.
Logged

Offline

  • Trade Count: (0)
  • Newbie
  • **
  • Posts: 34
  • Gender: Male
  • Location: California
Re: wiseco piston to cyl clearance?
« Reply #2 on: February 12, 2013, 12:29:24 pm »
Quote from: Iceracer on February 12, 2013, 12:11:25 pm
If you are meticulous about breakin and jet it correctly. .004. just be sure it dosent run lean and the shop that bores it gets it round and straight. .045 if your nervous. Remember at .008 its gonna rattle. when you start it.

Two years ago, I put a brand new engine on the Ice with .038" clearance It had been through a dozen heat cycles and its first ride was in practice. Its all about break in/warm up and proper tuning.

Thanks so much for the answer!
Logged
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store