+-
« previous next »
Pages: [1]   Go Down

Author Topic: Hot rot connecting Rod qestion!  (Read 663 times)

Offline

  • 1991 Lt250r
  • Trade Count: (0)
  • Elite Member
  • **********
  • Posts: 1350
  • Gender: Male
  • Location: West Virginia
Re: Hot rot connecting Rod qestion!
« on: May 28, 2013, 05:39:15 am »
Kyle the  the oem bearing in a hot rod rod lets the rod move side to side a 1inch  each way. When your pulling the rod side to side on the when the oem bearing is inserted on the crank pin. The hotrod bearings is probalbly  4 to 8mm taller then the oem bearing. Their is no way you could ever use oem bearing on a hotrod kit. Also the hotrod bearing will not fit inside oem rod.
Logged
91 Lt250r Bartlett port and head mod v force 2 Hinson Clutch Basket Cool Head Scp Pipe and silencer ,KN air filter ,EBC clutch, Ohlins  Triple rate Shocks Redone by PEP Shocks,Stock Rear Shock Redone By Pep Shock,  DG nerf Bars , Lonestar axle 2+2,Lonestar Swingarm ,Douglas Red Label rims.
Pages: [1]   Go Up
« previous next »
 

+- Suzuki Quadracer HQ Store Zone

http://www.suzukiquadracerhq.com/index.php?action=store