I will get some more pics when I get home tomorrow and post. I do know (but no measurements) the rod is the same. Same part numbers etc. I am using that crank in the PurplePeopleEater right now. I needed a crank short notice and it was true and had been welded. The bottom of the cylinder has been shaved down and the sleeve has a little different cut than stock. The piston says std but deft from something else. It is apx 3mm shorter from pin to top. Head is cut with large squish and shallow in my opinion. Port job has the bridge or whatever you call it completely cut out. I will post some more pics and measurements tomorrow.