swing arm and rear end options

swing arm and rear end options
Posted by Sledhead on 17 Oct, 2013 09:06
I'm going to be ordering a metal tech swing arm soon and wanted to know what rear end I should go with? I hear a lot of guys go with a banshee setup, if I were to go this route I'm assuming everything lines up as far as the sprocket and brake disk ect? I would also have to run all banshee components? Please shed some light on this and any other options I may have.

#2 Reply
Posted by Motoman991 on 17 Oct, 2013 13:01
Get a 250R style axle carrier. I assume that's what the Metal Tech swing arm will use?

#3 Reply
Posted by cworobec on 17 Oct, 2013 13:34
If you want to run a banshee set up everything lines up perfect, and yes you have to run all banshee components. If you decide to go that way let me know, I have a complete lonestar axcaliber axle with wheel hubs, brake hub and their heavy duty sprocket hub as well as a carrier. It literally has only 2 hours on everything.

#4 Reply
Posted by Rainman56 on 17 Oct, 2013 15:09
Quote from: Cworobec on 17 Oct, 2013 13:34
If you want to run a banshee set up everything lines up perfect, and yes you have to run all banshee components. If you decide to go that way let me know, I have a complete lonestar axcaliber axle with wheel hubs, brake hub and their heavy duty sprocket hub as well as a carrier. It literally has only 2 hours on everything.

Where are ya located and what did you switch to from that?

#5 Reply
Posted by Sledhead on 17 Oct, 2013 16:22
Will a Honda 250R rear end work? Any other options? Whats the best setup going to be?

#6 Reply
Posted by cworobec on 17 Oct, 2013 16:43
I am from Alberta, Canada but I can hip anywhere. I switched to an aluminum drag axle. And sledhead, they all use a Honda style round carrier.